Configuring Qos By Using The Cli; Figure 81 - Configure Client Qos Diffserv Policy Map Settings (Rule); Figure 82 - Configure Client Qos Vap Settings - D-Link DWL-2600AP Administrator's Manual

Unified Access Point Administrator's Guide
10.) For the class_voip Class Map, select the Mark IP Dscp option, and then select ef from the Select From List
menu.
11.) Traffic that meets the criteria defined in the class_voip class is marked with a DSCP value of EF (expedited
forwarding).
12.) Click Apply to save the policy.
13.) Navigate to the Client QoS > VAP QoS Parameters page.
14.) Select VAP 2 from the VAP menu.
15.) Make sure that the Client QoS Global Admin Mode and the QoS Mode are both enabled.
16.) From the DiffServ Policy Up menu, select pol_voip.
17.) Click Apply to update the AP with the QoS settings.

Configuring QoS by Using the CLI

ACL Configuration
1.) Connect to the AP.
2.) Create an ACL named acl1.
add acl acl1 acl-type ipv4
3.) Add a rule to acl1 that allows HTTP traffic from the 192.168.1.0 subnet.
add rule acl-name acl2 acl-type ipv4 action permit protocol ip src-ip 192.168.1.0 src-ip-
mask 0.0.0.255 src-port http
January 2015

Figure 81 - Configure Client QoS DiffServ Policy Map Settings (Rule)

Figure 82 - Configure Client QoS VAP Settings

Appendix B - Configuration Examples
Unified Access Point Administrator's Guide
Page 124