Configuring Qos By Using The Cli; Acl Configuration; Diffserv Configuration - D-Link DWL-3600AP Administrator's Manual

Unified Access Point Administrator's Guide
17. Click Apply to update the AP with the QoS settings.
Configuring QoS by Using the CLI
ACL Configuration
1. Connect to the AP.
2. Create an ACL named acl1.
add acl acl1 acl‐type ipv4
3. Add a rule to acl1 that allows HTTP traffic from the 192.168.1.0 subnet.
add rule acl‐name acl2 acl‐type ipv4 action permit protocol ip src‐ip 192.168.1.0 src‐ip‐mask
0.0.0.255 src‐port http
4. Add another rule to acl1 that allows all traffic from the host with an IP address of 192.168.1.23.
add rule acl‐name acl2 acl‐type ipv4 action permit protocol ip src‐ip 192.168.1.23 src‐ip‐mask
0.0.0.0
5. Enable Client QoS on the AP.
set client‐qos mode up
6. Enable Client QoS on VAP2
set vap wlan0vap2 qos‐mode up
7. Apply acl1 to VAP2 in the inbound direction (from the client to the AP).
set vap wlan0vap2 def‐acl‐up acl1
DiffServ Configuration
1. Log onto the AP CLI.
2. Create a class map named class_voip and configure it to match all UDP packets from the 192.168.1.0
network that have a destination IP address of 192.168.2.200 (the VoIP server).
D-Link
November 2011
Configuring Client QoS
Unified Access Point Administrator's Guide
Page 179