Viewing Interface Status; Wired Settings (Internal Interface); Wireless Settings; Figure 2: Viewing Interface Status - D-Link DWL-3600AP Administrator's Manual

Unified Access Point Administrator's Guide Viewing Interface Status
Viewing Interface Status
To monitor Ethernet LAN (wired) and wireless LAN (WLAN) settings, click the Interfaces tab.
Figure 2: Viewing Interface Status
This page displays the current settings of the UAP. It displays the Wired Settings and the Wireless Settings.
Wired Settings (Internal Interface)
The Internal interface includes the Ethernet MAC Address, Management VLAN ID, IP Address (IPv4 and IPv6),
Subnet Mask, and DNS information. To change any of these settings, click the Edit link. After you click Edit, you
are redirected to the Ethernet Settings page.
For information about configuring these settings, see "Configuring the Ethernet Settings" on page 25.
Wireless Settings
The Radio Interface includes the AeroScout™ Engine Communication status, Radio Mode and Channel. The
Wireless Settings section also shows the MAC address (read‐only) associated with each radio interface.
To change the Radio Mode or Channel settings, click the Edit link. After you click Edit, you are redirected to the
Modify Wireless Settings page.
For information about configuring these settings, see "Wireless Settings" on page 54 and "Modifying Radio
Settings" on page 58.
D-Link Unified Access Point Administrator's Guide
November 2011 Page 31