Figure 21: Configuring Wds Settings - D-Link DWL-3600AP Administrator's Manual

Unified Access Point Administrator's Guide
Before you configure WDS on the AP, note the following guidelines:
• When using WDS, be sure to configure WDS settings on both APs participating in the WDS link.
• You can have only one WDS link between any pair of APs. That is, a remote MAC address may appear only
once on the WDS page for a particular AP.
• Both APs participating in a WDS link must be on the same Radio channel and using the same IEEE 802.11
mode. (See "Modifying Radio Settings" on page 58 for information on configuring the Radio mode and
channel.)
• When 802.11h is operational, setting up two WDS links can be difficult. See "Using the 802.11h Wireless
Mode" on page 57.
• If you use WPA encryption on the WDS link over radio 1, VAP0 of radio 1 must use WPA Personal or WPA
Enterprise as the security mode. If you use WPA on a WDS link over radio 2, VAP0 of radio 2 must use WPA
Personal or WPA Enterprise as the security mode.
D-Link
November 2011
Figure 21: Configuring WDS Settings
Configuring the Wireless Distribution System (WDS)
Unified Access Point Administrator's Guide
Page 82