Section 6: Configuring Snmpv3; Configuring Snmpv3 Views; Figure 34: Snmpv3 Views - D-Link DWL-3600AP Administrator's Manual

Unified Access Point Administrator's Guide
Section 6: Configuring SNMPv3
This section describes how to configure the SNMPv3 settings on the UAP and contains the following
subsections:
• Configuring SNMPv3 Views
• Configuring SNMPv3 Groups
• Configuring SNMPv3 Users
• Configuring SNMPv3 Targets
Configuring SNMPv3 Views
A MIB view is combination of a set of view subtrees or a family of view subtrees where each view subtree is a
subtree within the managed object naming tree. You can create MIB views to control the OID range that
SNMPv3 users can access.
A MIB view called "all" is created by default in the system. This view contains all management objects
supported by the system.
Note: If you create an excluded view subtree, create a corresponding included entry with the same
view name to allow subtrees outside of the excluded subtree to be included. For example, to create a
view that excludes the subtree 1.3.6.1.4, create an excluded entry with the OID 1.3.6.1.4. Then, create
an included entry with OID .1 with the same view name.
D-Link
November 2011
Figure 34: SNMPv3 Views
Configuring SNMPv3
Unified Access Point Administrator's Guide
Page 111