D-Link DWL-3600AP Administrator's Manual page 93

Unified Access Point Administrator's Guide
Field Description
Username Enter the user name for the AP to use when responding to requests from an 802.1X
authenticator.
The user name can be 1 to 64 characters in length. ASCII printable characters are allowed,
which includes upper and lower case alphabetic letters, the numeric digits, and special
symbols such as @ and #.
Password Enter the password for the AP to use when responding to requests from an 802.1X
authenticator.
The password can be 1 to 64 characters in length. ASCII printable characters are allowed,
which includes upper and lower case letters, numbers, and special symbols such as @
and #.
Certificate File Indicates whether a certificate file is present and when that certificate expires.
Status
Certificate File Upload a certificate file to the AP by using HTTP or TFTP:
Upload
• HTTP — Browse to the location where the certificate file is stored and click Upload.
• TFTP — Specify the IP address of the TFTP server where the certificate file is located
Note: After you configure the settings on the Authentication page, you must click Apply to apply the
changes and to save the settings. Changing some settings might cause the AP to stop and restart
system processes. If this happens, wireless clients will temporarily lose connectivity. We recommend
that you change AP settings when WLAN traffic is low.
D-Link
November 2011
Table 34: IEEE 802.1X Supplicant Authentication (Cont.)
and provide the file name, including the file path, then click Upload.
Configuring 802.1X Authentication
Unified Access Point Administrator's Guide
Page 93