Table of Contents
Advertisement
3.1.3
Temporarily affix the Magnet.
3.1.4
Turn the crank slowly.
Check that the magnet does not come in contact with the senso.
3.2
Magnet Detection (For cycle computer other than Pioneer)
If using a cycle computer other than Pioneer, the magnet position can be checked as follows.
3.2.1
Preparations
Set the bicycle on a roller or other stand.
Remove then replace the batteries in the sensors. (Check must be done within five minutes.)
3.2.2
Detecting the Magnet Position
Rotate the crank slowly at around 30rpm. Check that the LED on each sensor lights up green once in very resolution.
If this is successful proceed to 3.3.3Fixing the Magnets.
If the LEDs do not light: either the sensor is too far from the magnet, or the magnet is not in the sensor's path. Check
3.1Temporarily affix the Magnet の again.
For the left and right sides, try to
affix the magnet so that it is within
1.5mm and 10.7mm of the sensor. If
this is not possible on the Chainstay,
try the Seat Tube (right photo) or the
Down Tube.
If this distance range cannot be
achieved, try using the Magnet Patch
Spacer.
13
LED lights green
Hide quick links:
Advertisement
Table of Contents
