Motorola AP-7131 Product Reference Manual page 252

6-36 AP-7131 Access Point Product Reference Guide
Tunnel Name
Remote Subnet
Remote Gateway
Key Exchange Type
NOTE When creating a tunnel, the remote subnet and remote subnet mask must
If access point #1 has the following values:
• WAN IP address: 20.1.1.2
• LAN IP address: 10.1.1.1
• Subnet Mask: 255.0.0.0
Then, the VPN values for access point #2 should be:
• Remote subnet: 10.1.1.0 or 10.0.0.0
• Remote subnet mask: 255.0.0.0
• Remote gateway: 20.1.1.2
3. If a VPN tunnel has been added to the list of available access point tunnels, use the
Tunnel Config
Tunnel Name
The Tunnel Name
access point
the
The Remote Subnet
tunnel. The remote subnet is the subnet the remote network uses
for connection.
The Remote Gateway
for each tunnel. The numeric remote gateway is the gateway IP
address on the remote network the VPN tunnel connects to. Ensure
the address is the same as the WAN port address of the target
gateway AP or switch.
The Key Exchange Type
passing keys between both ends of a VPN tunnel. If Manual Key
Exchange is selected, this column displays Manual. If Auto (IKE)
Key Exchange is selected, the field displays Automatic.
be that of the target device's LAN settings. The remote gateway must be
that of the target device's WAN IP address.
field to optionally modify the tunnel's properties.
Enter a name to define the VPN tunnel. The tunnel name is used to
uniquely identify each tunnel. Select a name best suited to that
tunnel's function so it can be selected again in the future if required
in a similar application.
column lists the name of each VPN tunnel on
.
column lists the remote subnet for each
column lists a remote gateway IP address
column lists the key exchange type for
VPN