Mitsubishi Electric GOT2000 Series User Manual page 137

■2. Installing the battery to GT2708, GT2705, or GT2508
The following shows the battery installation procedure, taking GT2708 as an example.
Step 1.
Make sure that the GOT power is off.
Step 2.
Install the battery inside the SD card cover on the side of the GOT.
Open the SD card cover as shown in the following figure.
Step 3.
To replace the battery, remove the old battery, and then disconnect the connector.
➠
6.7.2 Removing the battery
Step 4.
Insert the battery connector to the GOT connector.
Step 5.
After installing the battery to the battery holder of the GOT, close the SD card cover until it clicks.
SD card cover
Connector
Battery
Battery
Connector
SD card cover
Black cable
Red cable
SD card cover
6.7 Installing and Removing the Battery
6
6 - 23