Hitachi AJ-S55KXP User Manual page 9

How to Install the Water Drainage Hose
1
Connect the water drainage hose with the
water drainage joint on the back of the
body.
•
Fully insert it into place to avoid leakage.
Water drainage joint
3
1Insert the fixing holder of
water drainage hose into
mounting hole.
2As shown in illustration,
rotate the fixed leg for 90
degree into hole.
1Insert
2Rotate
Attention
•
To avoid direct draining due to the fallen water drainage hose, the water
drainage hose must be used only after installing into fixing holder, and its
hanging height should not exceed 1m.
•
Do not release the water drainage hose lest the water is splashed.
•
Do not use extended water drainage hose.
•
Do not immerse the U-shaped hose on the tail of the water drainage hose
in the water.
U
•
When using it in winter, to prevent icing, please release the water
drainage hose after using and place the its tail in water container such as
basin, set the washer to single dehydration mode and drain the remained
water. 44
•
Be sure not to install the water drainage hose at a position lower than water
drainage joint, otherwise, it could lead to difficulties in water drainage.
This discharge pipe installs the method to be only suitable in AJ-S55KXP.
AJ-S55KXP
2
Water drainage hose
4
Pull the water drainage
hose straight, concave
to fix into the fixing
holder of water drainage
hose.
90
Concave
Fixing holder
1
AJ-S55KXP
After the connection is completed, please
use hose clipper to clamp the water
drainage hose to avoid fall-off.
Water drainage hose from the right or (left) side
of the unit.
1m
Water drainage hose
44
Hose Clipper
Unplug U-shaped
hose and insert
into water
drainage hose.
U
9