Kenwood CKB200 Instructions For Use - Installation Advice page 14

ELECTRONIC CLOCK
The programmer is equipped with an
electronic clock with an illuminated dis-
play which indicates hours and minutes.
Upon immediate connection of the oven
or after a power cut, three zeros will
flash on the programmer display.
To set the correct time of day it is neces-
sary to push the
or button until you have set the
correct time (fig. 3.2).
Or push the two buttons
taneously and at the same time push the
or button.
Note: If the clock is reset it deletes any
previously set programs
NORMAL COOKING WITHOUT THE
USE OF THE PROGRAMMER
To manually use the oven, without the aid
of the programmer, it is necessary to can-
cel the flashing AUTO by pushing the but-
ton (AUTO will be switched off and the
symbol will illuminate - Fig. 3.3).
Attention: If the AUTO is lit (which means
a cooking program has already been set),
push the button
and return to manual operation.
If the oven is switched on, you must
switch off manually.
Fig. 3.3
14
(fig. 3.2)
button and then the
simul-
to cancel the program
ELECTRONIC TIMER
The timer consists only of a buzzer
which may be set for a maximum period
of 23 hours and 59 minutes.
If the AUTO symbol is flashing push the
button.
To set the time, push the
the or until you obtain the desired
time in the display panel (fig. 3.4).
Once set, the time will appear on the
panel and the symbol will be lit.
The countdown will start immediately and
may be seen at any time on the panel by
simply pressing the button
At the end of the time, the
disappear and the buzzer will sound
continuously for approximately 7 min-
utes or until a button is pressed (not the
/
buttons). After a short time the
display will revert back to the time of
day.
SETTING THE FREQUENCY OF THE
AUDIBLE SIGNAL
The buzzer has 3 different tones and
can be changed by pressing the
ton, but only when the time of day is dis-
played.
A
U
T
O
Fig. 3.4
button and
.
symbol will
but-