Network Standby; To Turn Off The Network Standby; Network Reset - Panasonic SC-ALL2 Operating Instructions Manual

∫ Network standby

This unit will turn on automatically from standby mode when you select the
unit as the output speakers.
≥ Network standby is normally active while the unit is connected to a network.
≥ The power consumption in standby mode will increase when the network
standby is active. To reduce the power consumption in standby mode, turn off
the network standby.

To turn off the network standby

1
Touch and hold [NET] and [2] for at least 4 seconds.
2
Touch [VOL –] or [VOL +] to select "OFF".
3
Touch [DISP] to confirm the setting.
≥ To keep the network standby turned off, select a source other than "NET"
before switching the unit to standby mode.
≥ To turn the function on, select "On" in step 2.
≥ If this function is set to on, the network (wired LAN/Wi-Fi) remains active even
in standby mode.
– The power consumption in standby mode will increase.
≥ If this function is set to off, the network (wired LAN/Wi-Fi) is disabled in standby mode.
– The network (wired LAN/Wi-Fi) will be enabled when the unit is turned on.
– The power consumption in standby mode will be reduced.
≥ If the network indicator is blinking in blue and red, wait until the blinking stops.
≥ When the unit is turned on by this feature, the beginning part of the music may
not be played back.
≥ Depending on the app, the conditions for activating this function may differ.
≥ The unit may not turn on even when selected as the output speakers. In that
case, start playback.
≥ The network standby is active if an alarm is turned on. (l 43)

∫ Network reset

1
Touch and hold [NET] and [1] for at least 4 seconds, "-- --" on the
display will start blinking.
2
Touch [NET] within 10 seconds, the network indicator starts blinking
blue/red.
- 16 -