To Make Network-Related Settings; Preparation - Panasonic SC-ALL2 Operating Instructions Manual

To make network-related settings

You can change this unit's name on the network, and use specific IP
address, subnet mask, default gateway, primary DNS, etc.
You can also change the name of this unit by changing a setting in the app
"Panasonic Music Streaming" (version 2.0.8 or later) (l 21). For details on the
app, refer to the site below.
http://panasonic.jp/support/global/cs/audio/app/ (This site is in English only.)

Preparation

≥ Complete the network settings. (l 12)
1
Connect your device to the same network as this unit.
2
Check this unit's IP address (l 46), and note it down.
3
Start an Internet browser on your device and then type this
unit's IP address into the address field to display the settings
page.
≥ It may take a few minutes until the settings page is displayed depending on
the environment. In that case, reload the browser.
≥ If the unit is connected with Wi-Fi, only a device name can be changed.
Close the settings page after changing the device name.
– To change the device name, select "Change", and type a new device
name, and then select "Apply".
4
Type a device name and then select "Next".
≥ Refer to the step 4 of "Using an Internet browser" (l 14) for details on a
device name.
5
Select and input the details.
≥ If your network requires specific settings, deselect "DHCP" to disable DHCP.
– You can use specific IP address, subnet mask, default gateway, primary
DNS, etc.
6
Select "Connect" to apply the settings.
≥ When the connection is established, the network indicator (blue) lights up.
- 20 -