Table of Contents
Advertisement
- Sets frame rate
Set the following value to "AcquisitionFrameRate" register. Setting value is Float type.
The range of register setting depends on camera model, and camera operation mode.
FrameRate
Minimum
Maximum (*)
Depend on register setting of "Height", "Binning", "Decimation", "PacketSize" and "PixelFormat" or link
speed of interface.
● Note
Changing "AcquisitionFrameRate" register value is invalid during image stream data output.
When exposure time setting is longer than frame rate setting, camera operation gives priority to exposure
time setting.
Notes on Frame Drops of Image:
Depends on your PC or Gigabit Ethernet interface board configurations, images may not be captured normally (e.g.
frame drops may occur). In this case, change to frame rate setting lower.
Copyright © 2014 TOSHIBA TELI CORPORATION, All rights reserved.
Value
0.0625[Hz]
45 / 80
* initial factory setting
D4235067D
http://www.toshiba-teli.co.jp/index.htm
Advertisement
Table of Contents
