Table of Contents
Advertisement
● Setting
- Set Manual Gain
Set the following value to "Gain" register. Setting value is Float type. This setting value is valid only at
Manual Gain mode setting.
The formula of Gain value is as follows;
- Select Gain control mode
Set the following value to "GainAuto" register. Setting value is Enumeration type.
● Note
About the details of AGC mode, refer to "ALCControl" of "Functions".
Notes on gain setting:
Setting the gain value too high increases noises. When you adjust the brightness of the image, I ask you to have final
image quality checked with your environment.
Copyright © 2014 TOSHIBA TELI CORPORATION, All rights reserved.
Gain
Minimum (*)
Maximum
output signal = input signal x 10
Value
Off (*)
Manual Gain Control (MANUAL)
Continuous
Auto Gain Control (AGC)
61 / 80
Value
0.00 [dB]
18.00 [dB]
* initial factory setting
Gain
20
Mode
* initial factory setting
http://www.toshiba-teli.co.jp/index.htm
D4235067D
Advertisement
Table of Contents
