Sanyo SFX-33 Service Manual page 27

E50-E59 Cut-off other party
CODE
50
51
52
53
54
59
CONTENTS
DCN reception or unknown
command
No polling original in the other
party
Triple trial of DCS, DTC or
NSS signal
T6 time over
CLASSIFICATION
T, R
T
R
1'
Carrier drop during Phase C R
Q, PRI-Q triple trial
T
Multi page (mode change) T1
T
time over
SYMPTOM and NOTES
Check the communication status between
the parties. When [STOP] key is pressed by
the transmitter, DCN signal comes after
PIX.(PIX: picture, signal)
Check the communication status between
the parties. If the other party could not
receive DCS signal, DIS signal would be
retransmitted. In other cases, it is possible
that the other party disconnected the line by
some reasons.
Although MCF signal to respond MPS or
CFR signal was transmitted, no carrier
signal received within 6 seconds.
Q: EOP, MPS, EOP General terms
E60 - E62 Incomplete transmissions due to deficient line
CODE CONTENTS CLASSIFICATION SYMPTOM and NOTES
60
Fall-down Out T Training failure even with fall-down to 2400
bps.
62
Continuous 300 BPS T, R This error may be caused by the line noise.
71 Unhatching of key code R
Telephone number does not match when
closed network communication.
E80 - E85 DCS, NSS command error
CODE CONTENTS CLASSIFICATION SYMPTOM and NOTES
80
Other company's NSS R
\
-
I 81
I No R command (Receive command) I
R I I
I 82 I Oriainal size A3
I
R
I
I
83 B4 command for A4 machine R
1
1 1
I 85 I Minimum transmission timer error I R
I
I