Sanyo SFX-110 Service Manual page 10

(6)-2 Programming dialing memory
.—
Up
to
28 telephone or fax numbers (and corresponding names) can be stored in the memory. The fax/phone numbers
stored to each of the 8 one-touch dialing keys (1-8) can be dialed out at the touch of a single key.
An additional 20 numbers can be stored using the speed-dialing numbers (01-20).
One-touch dial number programming
1. Press [MENU] twice.
2. Press [SET].
3. Press one-touch dialing key (1 -8).
Example: To program a number in the one-touch
key 2, press [one-touch key 2].
4. Press [SET].
12:0. T & S.D SET? I
O.T
No. =
?
O.T
No. =
?
—
5. Enter
the party's
name (to a maximum
of 16 characters).
EDWARD~
iABCDE
6. Press [SET].
7. Enter the fax (or telephone) number.
(A maximum of 32 digits can be entered including
pauses and hyphens.).
Example: 1-222-3333
8. Press [SET].
To program other one-touch numbers, repeat
steps 3-8 above.
9. Press [STOP] to finish one-touch number programming.
11-222 -3333~ I
loTNo,=~71-
SFX-21O:I26 Jun. 12:00 001
SFX-110: 26 Jun. '96 12:00
For instructions on printing out a numerical list of programmed names and numbers.
To interrupt programming, press [STOP].
To enter a hyphen (–), press [SPEED DIAL].
To enter a three-second pause between two digits of a number, press [REDIAL/P] in the appropriate place.
A semicolon (;) in the display indicates a pause.
If you make a mistake in entering fatiphone number, position the cursor over the digit to be changed using the
cursor keys [ P ] key (one-touch key 6) or [ < ] key (one-touch key 5), and press [DELETE] (one-touch key 8) to
delete the digit. Then enter the correct digit.
9