Tagging For Service; Packaging For Reshipment; Installation; System Cabling - HP 5501B Operating And Service Manual

Laser head

Table of Contents

2-11. Tagging for Service

2-12.

If the instrument is being returned to Hewlett-Packard for service, please complete one of the

blue repair tags (HP Part Number 9320-3896) located at the end of this manual and attaches it to

the instrument.

2-13. Packaging for Reshipment

1. Original Packaging

The same containers and materials used in factory packaging can be obtained through

Hewlett-Packard Sales and Support Offices listed at the rear of this manual.

In any correspondence refer to the equipment by model number.

2. Other Packaging Methods

If it becomes necessary to reship equipment, good commercial packing should be used.

Contract packaging companies can provide dependable custom packaging on short

notice. The following general instructions should be followed when repackaging with

commercially available materials.

If shipping to a Hewlett-Packard Support Office or Center, attach a blue tag indicating

the type of service required, return address, and model number.

Wrap the equipment in heavy paper or plastic.

Use a strong shipping container. A double-wall carton made of 350 pound test material

is adequate.

Use enough shock-absorbing material (three to four inch layer) around all sides of the

equipment to provide a firm cushion and prevent movement inside the container.

Seal the shipping container securely.

Mark the shipping container FRAGILE to assure careful handling.

2-14. Installation

2-15.

The following paragraphs provide installation information for the HP5501B Laser Head including

system cabling, grounding considerations, power supply requirements, power dissipation, fusing,

and mounting and fixturing.

2-16. System Cabling

2-17.

The HP5501B Laser Head is designed for use with the HP5501A Laser Transducer System and

is a direct replacement for the HP5501A Laser Head. The HP10778B Power and HP10779B

Reference cables (Figures 2-1 and 2-2 respectively), are available for connecting the laser head

to the laser transducer system.

2-18.

The HP10778B and HP10779B cables are both 10 Meters (32.8 ft) in length.

2-2

HP5501B

Installation