Table of Contents
Advertisement
Chapter 2
Switch Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
Warning
For connections outside the building where the equipment is installed, the following ports must be
connected through an approved network termination unit with integral circuit protection: 10/100/1000
Ethernet. Statement 1044
Warning
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of:
113°F (45°C)
If you use the FIPS kit, observe the following information regarding the ambient temperature:
Warning
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of:
104°F (40°C)
For more information on the FIPS kit, refer to the Installation Notes for the Catalyst 3750-X and 3560-X
Note
Switch FIPS Kit at this URL:
http://www.cisco.com/en/US/docs/switches/lan/catalyst3750x_3560x/hardware/install/notes/fips_install_note.pdf
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
To prevent airflow restriction, allow clearance around the ventilation openings to be at least:
Warning
3 in. (7.6 cm)
Statement 371—Power Cable and AC Adapter
OL-19593-03
Statement 1047
Statement 1047
Statement 1076
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
Preparing for Installation
2-3
Advertisement
Table of Contents
