Connecting The Stackpower Ports To The Xps 2200; Installing A Network Module In The Switch - Kenwood 3750-X Hardware Installation Manual

Connecting the StackPower Ports to the XPS 2200

Connecting the StackPower Ports to the XPS 2200
Before connecting the StackPower cables, review the
Switches)" section on page
To prevent misconfiguration, the StackPower ports on the switch and the XPS 2200 are keyed and have
colored stripes that match the keying and stripes on the StackPower cable ends.
Connect the end of the cable with a green stripe to the connector marked XPS on the switch. Align the
Step 1
connector correctly, and insert the end of the cable with a green stripe into an XPS port on the switch
rear panel.
Step 2 Connect the end of the cable with a red or yellow stripe to an XPS 2200 power supply.
Step 3 Hand-tighten the captive screws to secure the StackPower connectors in place.
Figure 2-21
Caution

Installing a Network Module in the Switch

These sections describe how to install and remove network modules or the blank module. See the
"Network Modules" section on page
There must be a supported network module in the network module slot. If no uplink ports are required,
Note
insert a blank network module. An empty slot generates error messages.
The network module is hot-swappable. If you remove a module, replace it with another network module.
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
2-22
2-9. Always use a Cisco-approved StackPower cable to connect the switches.
Connecting the StackPower Cable to an XPS 2200 Port
A U X
L E
C O N S O
2
S T A C K
1
S T A C K
3
2
1
RE SE T
Removing and installing the StackPower cable can shorten its useful life. Do not remove and
insert the cable more often than necessary.
"Planning a StackPower Stack (Catalyst 3750-X
R E S E T
7
6
5
4
1-7.
Chapter 2 Switch Installation
(Figure
S -P W R
X P S
S -P W R
9
8
2-21)
OL-19593-03