Kenwood 3750-X Hardware Installation Manual page 55

Chapter 2 Switch Installation
Remove the dust covers from the StackPower cable connectors.
Step 1
Connect the end of the cable with a green stripe to either StackPower connector on the first switch. Align
Step 2
the connector correctly, and connect the cable to a StackPower port on the switch rear panel.
(Figure
Step 3 Connect the end of the cable with the yellow stripe to another Catalyst 3750-X switch (to configure
StackPower power sharing) or to an XPS 2200 power supply (to configure redundancy).
Step 4 Hand-tighten the captive screws to secure the StackPower connectors in place.
Figure 2-20
Caution
OL-19593-03
2-20).
Connecting the StackPower Cable to a StackPower Port
A C O K
S -P W R
X P S
S -P W R
Removing and installing the StackPower cable can shorten its useful life. Do not remove and
insert the cable more often than necessary.
Connecting to the StackPower Ports (Catalyst 3750-X Switches)
A C O K
W A C
W R -7 15
C 3K X -P
P S O K
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
2-21