Electrolux EN19WI30LS Installation Manual page 38

Remote Controller
Installation Guide
Note
Do not connect power to the water heater before the remote controller has been properly installed.
Recommended installation location of the remote controller is in a bathroom.
Included Parts List
Part Name
Remote Controller
Wall Packing
Phillips Roundhead Wood Screw
Wall Anchor
Do not disassemble the remote controller.
Notes on the Installation Location
• The remote should be installed in an easily
accessible location.
• Avoid installing in a place where water
or steam can come into contact with the
controller.
• Avoid locations where special chemical agents
(e.g., benzene, fatty and oily detergents)
are used.
• Avoid outdoor installation, or installation in
an indoor location where it will be exposed
to direct sunlight.
36
Wall Packing
Quantity
1
1
2
2
Remote Controller
Connection of Remote Controller Cord
White Connector
Y-shaped terminals To Water Heater
(two-core)
* Confirm the connection with the labels at
both ends of the remote controller cord.
• A 26' (8m) cord can be purchased
separately (Part # RC-CORD26).
• The remote controller cord can be extended
up to 300 ft (90m). by splicing the cord and
using 18 gauge wire to extend the cord to
the appropriate length.
For Installers:
Read this installation guide
carefully before carrying out
installation.
Electrolux Home Products, Inc.
Connecting Wire
Phillips Roundhead
Wood Screw
To Remote Controller
Wall Anchor