Mx-Fr33/Fr33U (Data Security Kit) - Sharp MX-4110N Installation Manual

MX-5111N

[25] MX-FR33/FR33U (DATA SECURITY KIT)

1. Unpacking
A. Packed items check
1 2
No. Name
1 Program ROM
2 Product key sheet
3 User manual (CD-ROM)
4 Firmware program (USB memory)
2. Installation
NOTE: Before installing the data security kit, be sure to perform
backup of data stored in the memory (including HDD) of the
main unit.
When the data security kit is installed, all the job data
stored in the memory (including HDD) of the main unit will
be lost.
NOTE: If the LINE indicator or the DATA indicator for the printer
and image transmission on the operation panel is lit or
blinking, data that has not been processed remains in the
memory of the main unit (including HDD). Output or trans-
mit all the data to clear the data remaining in the main unit
and then start installation.
NOTE: Before installation, be sure to turn both the operation and
main power switches off and disconnect the power plug
from the power outlet. Make double sure that the data lamp
on the operation panel does not light up or blink when per-
forming installation.
A. Pull out the control PWB.
• If cables are connected to the control PWB unit, remove all
cables.
1) Push the location indicated in the illustration to unlock, and
remove the ozone filter cover from the right rear cabinet.
3 4
Quantity
1
1
1
1
MX-5111N MX-FR33/FR33U (DATA SECURITY KIT) 25 – 1
Service Manual
2) Remove the screw from the right rear cabinet and remove the
right rear cabinet.
3) Remove the two screws from the control PWB unit.
4) Pull out the control PWB unit.
2
• If the fax box unit is installed, carry out steps 5), 6), and
7) additionally.
5) Remove the screw and remove the snap band.
6) Remove the interface cable from the frame.
7) Remove the connector.
8) Pull out and remove the control PWB unit.
B. Program ROM attachment
1) Attach the program ROM (Packed items) to the OPT ROM slot
of the MFP control PWB.
3
4
3
OPT ROM