Table of Contents
Advertisement
2)
Set the BOOT SW on the left upper side of the MFP control
PWB to OFF.
C. Reattach the control PWB and the right rear
cabinet.
• If the fax box unit is installed, carry out steps 1), 2), and 3)
additionally.
1)
Connect the interface cable to the control PWB unit.
2)
Push the interface cable into the recessed portion of the sheet
metal on the control PWB unit.
3)
Attach the snap band to the sheet metal of the control PWB
unit.
4)
Push the control PWB unit into the main unit.
5)
Secure the unit with the two screws.
6)
Fit the interface cable into the right rear cabinet cover.
7)
Attach the right rear cabinet cover to the main unit.
At this time, check that the four hooks are properly fitted to the
main unit.
MX-5111N MX-FR33/FR33U (DATA SECURITY KIT) 25 – 2
8)
Secure the right rear cabinet with the screw.
Hook 1 Hook 2
7
8
9)
Attach the ozone filter cover to the main unit.
• Reconnect the cables that have been removed in step A to the
original positions of the control PWB unit.
D. Turn ON the power of the main unit
1)
Connect the power plug of the machine to the power outlet,
and turn ON the main power switch and the operation panel
power switch.
E. Firmware update procedures
(1) Entering the boot mode
1)
When the power is turned ON, the main program error is dis-
played.
Main Program Error!!
2)
The above error message is displayed for 10 sec. Then the fol-
lowing message is displayed.
Emergency Prog Init
Please wait
3)
The machine enters the boot mode which indicates that there
is an error in the main program.
Version Check
IcM:UNUSUAL
Hook 3
Hook 4
6
Hide quick links:
Advertisement
Table of Contents
