Table of Contents
Advertisement
2)
Remove two screws from the scanner bottom.
3)
Connect the harness of the scanner heater. Install the heater
fixing plate of the scanner heater unit, and secure it with the
screw (M3x4 Round-tipped) (package part No. 17).
4)
Install the scanner heater and secure it with the screw (M4x6
Bind machine screw) (package part No. 18). Pass the harness
through the clamp.
NOTE: The convex part of the scanner heater must be inserted
into the hole of the scanner frame.
5)
Tighten the loose scanner heater harness by pulling it in the
arrow direction and secure it with the snap band (packing part
No. 19) then cut its tip to approx. 5 mm or less.
6)
Move the lamp unit by hand and check that it move smoothly in
all movable area.
NOTE: Check that there is no interference of the harness of the
(4) Installation of the table glass, the paper exit cover
1)
Install the paper exit cover.
MX-5111N Dehumidifying heater 3 – 6
scanner heater in the wire and the 2/3 mirror unit.
Hide quick links:
Advertisement
Table of Contents
