Loading Media Into The Printer - Toshiba B-852-TS12-QP Owner's Manual

2. PRINTER SETUP
2.7.2 Installing the Supply
Holder Unit onto the
Supply Holder Frame
NOTE:
Make sure that the brass
bushings of the Supply Shaft
are seated into the notches so
that the entire Supply Holder
Unit rotates smoothly.
CAUTION!
The reassembled Supply
Holder Unit and media roll
may be quite heavy, so be
careful not to pinch your
fingers when installing the
Supply Holder Unit onto the
Supply Holder Frame.
2.7.3 Loading Media into the
Printer
1. Insert the assembled Supply Holder Unit into the rear notches of the
Supply Holder Frame as shown in the diagram below.
Rear Notch
2. Now feed the media from the bottom of the media roll into the media
slot at the rear of the printer as shown.
The following paragraphs outlines how to properly install the media into
the printer from the Supply Holder Unit that has been installed in the
previous steps.
1. Raise the Top Cover as shown in the diagram below.
Top Cover
E2- 9
ENGLISH VERSION EO1-33028
2.7 Loading the Media
Brass Bushing
Supply Holder
Frame
Rear Notch