Table of Contents
Advertisement
v UPS supply: Green light; when active, the UPS output is available, and the
v Bypass mode: Red light; when active, indicates that the HotSwap MBP is in
Normal AC source switch and Bypass AC source switch: Use to switch off the AC
source for the UPS (for UPS maintenance and replacing)
MBP status detection: A signal cable, with RJ11 connector to plug to the UPS,
allows the UPS to manage the MBP status and display the following on the UPS
display panel:
v MBP connection to UPS
v Bypass switch position
Figure 6. 8/11k VA 1Phase
Figure 7. 8/11k VA 3Phase
16
Installation and User's Guide
Bypass switch can safely be turned to UPS position
Bypass mode (Bypass switch turned to Bypass position)
Input/Output terminal blocks
Input/Output terminal blocks
for connection to the UPS
Normal AC source switch
Signal cable for MBP detection
to the UPS
Bypass switch
(3) 30A outlets
30A circuit breaker
UPS supply green light
"Bypass" mode red light
Input/Output terminal blocks
Input/Output cables for
connection to the UPS
Bypass terminal blocks for
connection to the UPS
Normal AC source switch
Bypass AC source switch
Signal cable for MBP detection
to the UPS
Manual Bypass switch
(4) C20 16A outlets
UPS supply green light
Bypass mode red light
Advertisement
Table of Contents
