Output Shaft Speed Sensor Removal And Installation; Output Shaft Speed Sensor Inspection; Input Shaft Speed Sensor Removal And Installation - Suzuki Swift Sport 2004 Service & Repair Manual

5A-96 Automatic Transmission/Transaxle:
Output Shaft Speed Sensor Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Disconnect output shaft speed sensor connector (2).
3) Remove output shaft speed sensor (1) by removing
its bolt.
Installation
1) Apply A/T fluid to output shaft speed sensor O-ring.
2) Install output shaft speed sensor (1) to A/T case and
tighten bolt to specified torque.
Tightening torque
Output shaft speed sensor bolt (a): 13 N·m (1.3
kgf-m, 9.5 lb-ft)
3) Connect output shaft speed sensor connector (2) to
output shaft speed sensor (1).
4) Connect negative cable to battery.

Output Shaft Speed Sensor Inspection

1) Connect positive cable of 12 volt battery to "A"
terminal of sensor and ground cable to "C" terminal.
Then using voltmeter, check voltage between "B"
terminal and "C" terminal with output shaft speed
sensor driven gear rotated.
If measured voltage (pulse signal) is not as
specified, replace sensor.
Output shaft speed sensor output voltage
Pulse signal of alternating 0 – 1 V and 10 – 14 V
S7RS0B5106016
2) Check output shaft speed sensor driven gear (1) for
wear.
Replace if necessary.
I3RM0B510040-01
Input Shaft Speed Sensor Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Disconnect input shaft speed sensor connector (2).
3) Remove input shaft speed sensor (1) by removing its
bolt.
I3RM0B510041-01
S7RS0B5106017
I2RH0B510045-01
I2RH0B510046-01
S7RS0B5106018
I2RH0B510047-01