Repair Instructions; Rear Wheel Alignment Inspection; Rear Shock Absorber Removal And Installation - Suzuki Swift Sport 2004 Service & Repair Manual

2C-2 Rear Suspension:

Rear Wheel Alignment Inspection

Measure toe and camber referring to "Front Wheel
Alignment Inspection and Adjustment in Section 2B".
NOTE
Rear suspension is not adjustable structure.
Rear toe (total)
: IN 3.8 ± 3.8 mm (IN 0.1969 ± 0.1969 in)
Rear camber
: –1° ± 1
If measured value is out of specified value, check
following items for damage, deformation and crack.
• Rear axle (torsion beam)
• Spindle, wheel hub or wheel bearing
• Vehicle body

Rear Shock Absorber Removal and Installation

Removal
1) Hoist vehicle and remove rear wheels.
2) Remove tail end member trim (1) and quarter inner
trim (2).
3
3. Clip
3) Support rear axle by using floor jack to prevent it
from lowering.
4) Remove shock absorber lower nut.
5) Remove shock absorber upper nut. Then remove
shock absorber, a pair of upper washers and lower
washer.

Repair Instructions

S7RS0B2306017
S7RS0B2306001
3
2
3
1
3
I7RS0B230001-01
Installation
1) Install shock absorber (1), a pair of upper washers
(2) and lower washer.
Tighten new rear shock absorber upper nut (4) and
lower nut temporarily at this step.
CAUTION
!
Never reuse the removed rear shock
absorber upper nut.
NOTE
A pair of upper washers (2) are installed as
shown in figure.
1
3. Body panel
4
2
3
I6RS0C230005-01