Motorola GP68 Installation And Operation Manual page 11

1
2
3
4
5
9
0
Routing codes 1 and 2 give the subscriber access to tele-
phone line one or two respectively. A subscriber may be
restricted from line 2, or there may not be two telephone
lines connected to the ST-852M. In this case, routing code
2 is not valid.
Routing code 3 allows the subscriber to place a call to an-
other subscriber or group of subscribers. The call is routed
through the ST-852M and does not use the telephone sys-
tem.
Routing code 4 allows the subscriber to place a call to the
subscriber's own group. This functions as though the sub-
scriber had used routing code 3 with the subscriber ID num-
ber of the subscriber's own group. When automatic PTT is
enabled, operation of the PTT initiates a group call to the
subscribers group using routing code 4.
Routing code 5 selects conventional mode. In this mode,
radio channel switch positions not used by SmarTrunk II
trunking channels may be programmed and used for con-
ventional two-way radio operations. This feature is enabled
or disabled during initial setup of the radio. Availability of
this mode is determined by the radio dealer supplying the
radio, or the System Operator/Manager.
Subscriber to Landline 1
Subscriber to Landline 2
Subscriber to Subscriber
Fleet-Dispatch/Group Call
Conventional Mode
Mobile Operator
Emergency
1 • Operation
11