Automatic Ptt Mode; Emergency Call Override - Motorola GP68 Installation And Operation Manual

To program the ST-865M3 with a trunking system ID
number: Enter the program code 20 followed by the #
key, and then the trunking system ID number followed
by the # key.
Example: To program the Trunking System ID
Number to 5 press:
The Automatic PTT mode makes radio operation simple
for the dispatch operation. With this mode enabled, the
subscriber simply presses the PTT switch on the radio
to gain channel access. The ST-865M3 will automati-
cally call the subscriber's Secondary code for fleet-dis-
patch type trunking systems. No keypad entry is re-
quired to operate in this mode.
Note: This option should not be used if the primary
function of a subscriber is for radiotelephone.
Both radiotelephone and fleet-dispatch mobiles
can share the same trunking system.
To program the automatic PTT mode: Enter the pro-
gram code 21 followed by the # key, and then either 1
(enable) or 0 (disable) followed by # key.
Example: To enable automatic PTT mode press:
2 1 # 1 #.
When a subscriber places an emergency call by using
routing code 0 (pressing *0), the ST-865M3 will dial the
pre-programmed emergency phone number on line 1. If
all channels are busy and Emergency Call Override is
enabled, it will automatically begin a priority call over-
ride function to dial the emergency phone number. See
the ST-852M SmarTrunk II Digital Trunking Control-
ler manual for details on programming the emergency
phone number.
To program the Emergency Call Override feature: Enter
the program code 22 followed by the # key, and then
either 1 (enable) or 0 (disable) followed by the # key.
Example: To enable Emergency Call Override press:
2 2 # 1 #.
4 • ST-865M3 Programming
2 0 # 5 #.
37