Motorola GP68 Installation And Operation Manual page 31

4 • LOGIC BOARD PROGRAMMING
T
he ST-865M3 provides the installing technician a flexible programming
capability after the ST-865M3 has been installed in the radio. The ST-
865M3 is programmed by using the keypad on the front of the radio. No
special cables or other attachments are required. All programming information
is retained in a non volatile EEPROM.
To test the installation and programming of the ST-865M3, a functional ST-
852M with the system ID numbers and paging codes correctly programmed is
required. See the ST-852M SmarTrunk II Digital Trunking Controller manual
for details on adding subscriber ID numbers to the system.
To enter the programming mode, perform the following steps:
a. Turn the radio off.
b. Press and hold the # key on the front panel keypad.
c. Turn the radio on.
d. After the beep is heard, release the # key.
e. Enter the dealer programmed 5 digit access code, followed by the
# key. The default access code is 12345.
f. The ST-865M3 will respond with a high beep. If a low beep is
heard, the access code was incorrect. Turn the radio off and try
the procedure again.
The ST-865M3 programming features are described herein. A
programming worksheet is provided in Appendix A. This worksheet
should be copied and filled out for each subscriber and used as a
record of the programming for that particular subscriber.
31