Canopy T1/E1 Multiplexer
1.2.5
Front Panel
The control port and indicator LEDs are located on the front panel of the unit.
Status LEDS
The status indicator LEDS on the front of the Canopy T1/E1 Multiplexer are listed in
Table
3.
LED
PWR
RDY
CANOPY LINK
CANOPY ACT
LAN LINK
Issue 3
Figure 6: Canopy T1/E1 Multiplexer front panel
Table 3: LED status indicator descriptions
LED indicator descriptions
ON when main power supply is OK; OFF when a malfunction is
detected
ON when self-test is successfully completed; OFF during self-test; and
BLINKING when self-test fails
OFF when line is not active; ON when Canopy BH Ethernet line is OK
OFF when no activity; BLINKNG when frames are being transmitted or
received on the line
OFF when line is not active; ON when line is OK
Page 14 of 73
T1/E1 Multiplexer FPGA Version 3.4
September 2004