Canopy T1/E1 Multiplexer
Canopy BH
RJ-45
connector
TD+
TD-
RD+
Nc
Nc
RD
Nc
Nc
Figure 12: RJ-45 Ethernet connection pin-outs (LAN side)
Perform this procedure to connect the cables to the T1/E1 unit.
1. Connect the T1/E1 cables to the T1/E1 ports.
NOTE: There is a one-to-one relationship between the T1/E1 ports on the
Canopy T1/E1 Multiplexer. This means, that the T1/E1 cable connected to the
T1/E1 Port 1 on one of the Canopy T1/E1 Multiplexers, must also be connected
to Port 1 on the other.
2. Connect the Ethernet cables to the Ethernet ports.
3. Connect the power cable to the power connector.
2.2.5
Connecting Power to the Canopy T1/E1 Multiplexer
The Canopy T1/E1 Multiplexer is available in two power configurations:
◦
an external 3.3-v DC power source (supplied by Canopy)
◦
an external −48 v DC power supply with a terminal strip that plugs into the back
of the Canopy T1/E1 Multiplexer.
Issue 3
LAN
Pin
RJ-45
connector
1
TD+
White/Green
2
TD-
Green
3
RD+
White/Orange
4
Not used
Blue
5
Not used
White/blue
6
RD
Orange
7
Not used
White/brown
8
Not used
brown
Procedure 2: Connecting cables to T1/E1 unit
end of procedure
Page 30 of 73
T1/E1 Multiplexer FPGA Version 3.4
Color
September 2004