Table of Contents
Advertisement
Canopy T1/E1 Multiplexer
3. Place the Canopy T1/E1 Multiplexer behind the desired Rack Panel mounting
hole.
NOTE: The Rack Panel will support three (3) Canopy T1/E1 Multiplexers.
4. Place the Front Panel on the front of the Rack Panel opening, positioning the
Rack Panel Spacer between the two panels.
5. Insert the front panel mounting screws through the screw holes.
6. Tighten screws.
7. Insert the screw posts onto the DB-9 connector.
8. Tighten screw posts.
9. Mount the Canopy T1/E1 Multiplexer with the rack panel onto your rack unit.
Consult the product information supplied by the rack manufacturer for details.
NOTE: The front panel mounting screws should be 4-40 screws, between 3/8"
and 5/8" long.
2.2.4
Connecting the Canopy T1/E1 Multiplexer
Pin
1
2
3
4
5
6
7, 8
Issue 3
Figure 11: Front panel and front bezel removed
end of procedure
Table 12: T1/E1 port connector pin-out
Designation
Direction
RD(R)
Input
RD(T)
Input
FGND
TD(R)
Output
TD(T)
Output
FGND
FGND
Not connected
Page 29 of 73
T1/E1 Multiplexer FPGA Version 3.4
Function
Receive data (ring)
Receive data (tip)
Transmit data (ring)
Transmit data (tip)
September 2004
Advertisement
Table of Contents
