Table of Contents
Advertisement
Canopy T1/E1 Multiplexer
Action
Set timing mode
Log off
2.5 CONFIGURATION PROCEDURES USING THE EMS
2.5.1
Logging into the System
If you are using the EMS to access the system, follow the steps below to log in:
1. Select the proper COM Port for your PC.
NOTE: COM1 through COM4 are supported.
2. Enter the User Name.
NOTE: The default username is admin. This value cannot be changed.
3. Enter the Password.
NOTE: The default password is 123. If the password has been changed, enter
the correct password.
4. Select the Login button to continue with the login.
NOTE: If the login is unsuccessful, the system will generate a pop-up error
window. You may return to the Login window to correct the data.
Issue 3
NOTE: Timing mode applies to all four E1 lines. Loopback mode loops the T1/E1
Tx clock to the T1/E1 Rx. Recovered mode recovers the T1/E1 clock from the
incoming T1/E1 over Ethernet bit stream (recovers the clock from the far end
T1/E1). The default timing mode is Recovered.
For master clock timing mode, enter
set clock source loopback
RESULT: The system responds
Clock source is loopback
For slave clock timing mode, enter
set clock source recovered
RESULT: The system responds
Clock source is recovered
Enter lo.
RESULT: The system responds goodbye.
end of procedure
Procedure 14: Logging in using the EMS
Page 45 of 73
T1/E1 Multiplexer FPGA Version 3.4
Steps
September 2004
Advertisement
Table of Contents
