Motorola APX 5000 Service Manual page 122

Sec 1: 8-22
4. Replace the RF Coax Cable. Bend and seat the new RF cable within the chassis grooves as
noted in step 3.
5. Torque both screws (44) with a Torx IP8 Bit and a torque Driver to 8 in-lbs.
NOTE: There are no other serviceable components on the Main Chassis Assembly (E).
8.8.2 Servicing Control Top Assembly (F)
8.8.2.1 Control Top Main Seal
1. Complete steps from
2. Remove the Control Top Seal (22) with the Black Stick.
3. Replace the new seal into the groove provided in the Control Top Assembly's casting.
4. Ensure that seal is set properly and not stretched.
NOTE: There are no other serviceable components on the Control Top Assembly (F).
Disassembly/Reassembly Procedures: Serviceable Components of the Main Sub-Assemblies
Chassis Ground Contact (18)
Figure 8-30. Remove Chassis Ground Contact
Figure 8-31. Control Top Assembly and Control Top Seal
Section 8.7.1.
Control Top Assembly (21)
Control Top Seal (22)
through Section 8.7.9. of section 8.7 on page 1:8-13.