Motorola APX 5000 Service Manual page 138

Sec 1: 8-38
4. While holding the Speaker Module down, place the two top screws (42) into the their
respective holes and torque the screws to 10 in-lbs with an IP8 Torx Bit in a torque driver. See
Figure
IMPORTANT:
8.9.1.9 Assemble Speaker Grille Assembly (K)
1. Install the Speaker Grille (K) by inserting the top lip under the Control Top Bezel (24) and
rotating the grille into place. See
NOTE: Ensure the Vacuum Port Seal is in place and the Vacuum Port Seal screw shaft is
2. Insert the two center screws (41) and torque to 10 in-lbs. See
3. If removed, insert the two bottom screws (43) into the screw holes at the bottom of the radio
as shown in
8-52.
For proper sealing, Speaker Module (J) must be held down during the
torquing of the screws.
Figure 8-52. Insert Top Screws
Figure 8-53. Insert Center Screws
aligned with the screw hole.
Figure 8-54., and torque to 10 in-lbs.
Disassembly/Reassembly Procedures: Radio Reassembly
Top Screws (42)
Speaker Cone
Figure 8-53.
Center Screws (41)
Vacuum Port Seal
Figure 8-53.