Figure 8-52. Insert Top Screws; Figure 8-53. Insert Center Screws - Motorola APX 5000 Service Manual

Disassembly/Reassembly Procedures: Radio Reassembly
4. While holding the Speaker Module down, place the two top screws (42) into the their
respective holes and torque the screws to 10 in-lbs with an IP8 Torx Bit in a torque driver. See
Figure
IMPORTANT:
8.9.1.9 Assemble Speaker Grille Assembly (K)
1. Install the Speaker Grille (K) by inserting the top lip under the Control Cap Assembly (58) and
rotating the grille into place. See
NOTE: Ensure the Vacuum Port Seal is in place and the Vacuum Port Seal screw shaft is
2. Insert the two center screws (41) and torque to 10 in-lbs. See
8-55.
For proper sealing, Speaker Module (J) must be held down during the
torquing of the screws.
Figure 8-55. Insert Top Screws
Figure 8-56. Insert Center Screws
aligned with the screw hole.
Top Screws (42)
Speaker Cone
Figure 8-56
Center Screws (41)
Vacuum Port Seal
Sec 2: 8-39
Figure 8-56.