Group Setting - Mitsubishi Electric AG-150A Instruction Book

4-3 Group Setting

Display the page needed to register the group of air conditioners or general equipment to be connected to the
AG-150A and to set the group name by clicking [Initial Settings]-[Groups]. On this page, you perform the basic
setting such as the AG-150A unit name, network setting and M-NET setting. Click [Set to AG-150A] to send
setting data to the AG-150A.
Note: If PAC-YG50ECA Expansion Controllers are connected, Expansion Controller system selection buttons will appear. Select
the desired Expansion Controller (EC1, EC2, or EC3), and make the settings for each system.
Note: If the user logs in as a building manager, some of the operations may be prohibited.
Note: If the system is connected to the TG-2000A, make all settings and changes from the TG-2000A so that the data in
TG-2000A and AG-150A will match.
Note: A contact on the genera interface device is regarded as one unit. The number of units that can be connected to AG-150A is
up to 50.
Note: Air-conditioners and general equipment cannot be in the same group.
Note: Remote controllers or system controllers cannot be connected to general equipment.
Note: When connecting multiple AG-150A controllers by connecting an Expansion Controller, all controllers must have the same
control group settings.
CAUTION
Group No.
Group numbers will be
displayed here.
Group name
The group names are entered
here.
Refresh
Read setting data from AG-150A.
4-3-1 Setting the Group Name
(1) In the [Group Name for Web] field on the screen, register the group name to be displayed on the Web
screen, using a name consisting of no more than 20 characters.
Note: The following characters cannot be used in the group name: < > & " '
(2) Next, in the [Group name for LCD of the AG-150A] field, enter the group name to be displayed on the LCD
of the AG-150A consisting of no more than 10 numbers, upper case letters, hyphen, or space combined.
4-3-2 Registering air conditioner or hot water supply units in the group
(1) To register air-conditioners, clicking the [Air Conditioner or
general equipment or hot water supply Registration] field next to
each group in the [Groups] screen will bring up the [Select Unit
Addresses] screen. Click on the numbers corresponding to the
units to be registered. All selected units will be shown with a
yellow-green background.
To cancel the selection, click on them again. Deselected items will
be shown with a gray background.
Note: A maximum of 16 air conditioner units can be registered in one group.
Note: To change the registered units to air-conditioners in the group in which
general equipment is registered, disconnect the general equipment first.
(2) To change the icon, click the right or left arrow.
Control group settings on Expansion Controllers (PAC-YG50ECA), when connected, must be made
with the Expansion Controller properly connected to ensure proper settings.
19
Air Conditioner or general
equipment or hot water
supply Registration
Register the air conditioner or
general equipment or hot
water supply to be connected
here. Click to bring up the
registration screen.
Expansion Controller
system selection buttons
Click to select the system to
be set.
System Controller
Registration
Register the system controllers
to be connected here. Click to
bring up the registration screen.
Remote Controller
Registration
Register the remote controllers
to be connected here. Click to
bring up the registration screen.
Save Settings
Send setting data to AG-150A.