Mitsubishi Electric AG-150A Instruction Book page 35

5-3-6 Setting the destination to which temperature/humid trend data mail is sent
To send temperature/humid trend data by mail once a day (when the date changes), make the mail sending
settings. The trend data is sent as an attachment CSV file.
(1) Select the [Trend Data] in the Type of E-Mail
pulldown, and enter the Mail Subject and the E-Mail
Address.
Note: The following characters cannot be used in the mail title:
< > & " '
The following format will be applied to the attachment file attached to the mail that is sent when the date
changes.
121
23/01/2007
Address 50-1
Time,Temperature(deg C)
00:00,20.3
00:05,20.1
00:10,19.8
00:15,19.3
:
23:50,18.8
23:55,18.5
(2) Click the [E-Mail Settings] to set the mail server
information.
Note: The setting details are the same as those mentioned in
the chapter 5-1-1 and 5-1-2. Refer to those chapters.
Item
121: Temperature data
File Type
122: Humidity data
dd/MM/yyyy
Date
Note: The date format set in section 4-2-4 will be
applied.
M-NET address of AI controller + sensor No.
Note: If an Expansion Controller is connected, the
Trend target
trend target will appear in the [Expansion
Controller No. ( )-[M-NET address of AI
controller]-[Sensor No.] format.
Measured item "Time,Temperature" or "Time,Humidity"
Time + Measurement data
Note: The data interval, separator character, decimal
Data
point character that are set in section 5-3-4 will
be applied.
34
Format