Electrolux ICON series Use & Care Manual page 7

Leveling Freezer Drawer
1 Check gasket seal around top, bottom, and
sides of freezer drawer.
2 If gasket is not sealed, open drawer and slightly
loosen four drawer screws (two on each side) to
allow drawer to rotate (see illustration).
3 Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B). Be careful not to rotate the drawer.
Remove hex
head drawer
screw
Do Not Remove
Other Screws
Remove
Hex
Head Drawer
Screw
4 Tighten four drawer screws.
5 Recheck gasket seal.
Push
Against
Freezer
Drawer
A
Level Refrigerator & Adjust Doors
(if necessary)
Guidelines for final positioning of your refrigerator:
• All four corners of the cabinet must rest firmly
on the floor.
• The sides should tilt ¼ inch (6 mm) from front to
back (to ensure that doors close and seal properly).
• Doors should align with each other and be level.
Most of these conditions can be met by raising or
lowering the adjustable front rollers.
To level the cabinet using the front rollers:
1 Slightly open freezer drawer.
2 Remove the toe grille (following the illustrations
below for the toe grille on your model).
(if necessary)
Remove hex
head drawer
screw
Remove
Hex
Head Drawer
Screw
Grab
Drawer
at Center
from Both
Sides
Then
Pull
Drawer
Out
B
Installation
Figure 1: Remove screws and then gently pull forward.
Figure 2: Lift the toe grille and gently pull forward.
Clip
Shoulder
Screw
3 You can raise or lower each door. Use a ⅜
inch socket wrench to turn the adjustment
screws (one per side).
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw counterclockwise.
4 Ensure both doors are bind-free with their seals touching
the cabinet on all four sides and that cabinet is stable.
5 After unit is leveled, lower anti-tip leg until it
contacts the floor.
Door
Raise
Anti-tip
Leg
Lower
6 Install the toe grille by fitting into place (replacing
screws on some models).
Remove
Mounting
Screws
Shoulder
Screws
Toe
Grille
Door
7