Electrolux ICON series Use & Care Manual page 9

4 Lift the door while adjusting the washer. To
raise the door, rotate washer clockwise (when
viewed from the bottom). To lower door, rotate
washer counter-clockwise (when viewed from
the bottom).
o r
D o
Lower
Door
Hinge
Washer
Raising/Lowering Door
5 Re-tighten the screw (where applicable),
ensuring it is between the spokes of the set
washer. Screw will not be tight, just insert until
it is flush with the hinge.
Re-tighten Screw
Hinge
Washer Spokes
Screw
Screw (where applicable)
NOTE
If after adjusting doors higher the door makes a
popping/clicking sound, remove screw and replace
with the longer one supplied in the handle package.
Raise
Door
To adjust the flipper mullion:
1 Loosen the screw located on the flipper mullion
hinge.
Flipper
Mullion
Hinge
Adjusting Flipper Mullion Screw
2 Adjust flipper mullion height. For proper
connection with the flipper mullion guide, there
should be a separation about the thickness of
a coin (0.060 inches, or 1.5 mm) between the
guide and flipper mullion.
Flipper
Mullion
Adjusting Flipper Mullion Height
3 Re-tighten screw.
Installation
Flipper
Mullion
Screw
Mullion
Guide
Thickness
of a Coin
9