Installation Under A Wall Cupboard - Silvercrest SKR 800 A1 Operating Instructions Manual

■ Do not place the device in a hot, wet or extremely damp environment or in the vicinity
GB
of flammable materials.
IE
■ The mounting location must be selected so that the device is not exposed to steam.
Do not install the device directly over a hotplate.
■ The mains power socket must be easily accessible so that the power cable can be
easily disconnected in an emergency.

Installation under a wall cupboard

You can install the device under a wall cupboard using the supplied mounting plate
Proceed as follows to mount the device:
♦ Slide the mounting plate to the rear and remove it from the device.
♦ Find a suitable installation location for the device (see also the section Set-up
location requirements).
♦ Hold the mounting plate under the installation location. Ensure that the front edge
of the mounting plate is approx. 3.1 cm behind the front of the cupboard so that the
device is flush with the cupboard after installation. The side edges of the mounting
plate must be around 6.3 cm from any adjacent cabinets or walls.
♦ Mark the 4 mounting points with a pencil.
♦ Using a spike or nail, make a small depression at the respective marking points.
♦ If required, place the supplied spacers
plate. If using the spacers, you will need the long mounting screws
♦ Screw the mounting plate tight using the mounting screws (
♦ Push the device with its top against the mounting plate
place.
♦ Check to ensure that the device is securely seated.
8
3,1 cm
6,3 cm
between the cupboard and the mounting
14
or
15
until it clicks audibly into
4
.
4
.
15
) provided.
16
SKR 800 A1