Installation under a wall cupboard
Using the supplied mounting plate
wall cupboard. Proceed as follows to mount the device:
♦
Slide the mounting plate
♦
Find a suitable installation location for the device (see also the section
"Requirements for the set-up location").
♦
Hold the mounting plate
front edge of the mounting plate
the cupboard so that the device is flush with the cupboard after installation.
The side edges of the mounting plate
away from adjacent cabinets or walls.
♦
Mark the 4 mounting points with a pencil.
♦
Using a pin or nail, make a small depression at the respective marking
points. In hardwoods, drill a shallow hole in the markings using a ∅ 2.5 mm
wood drill bit.
♦
If required, place the supplied spacers
mounting plate. If you are using the spacers provided
long mounting screws
♦
Screw the mounting plate
h
or
♦
With the top of the device against the mounting plate
back until it clicks into place.
♦
Check to ensure that the device is firmly in position and safely route the
power cable
SKR 800 C3
u
u
g
.
u
).
o
and the wire aerial
u
, you can install the device e. g. under a
to the rear and remove it from the device.
under the installation location. Ensure that the
u
is approx. 3.1 cm behind the front of
u
must be spaced approx. 6.3 cm
f
between the cupboard and the
tight using the mounting screws provided (
i
.
3,1 cm
6,3 cm
f
, you will need the
g
u
, push the device
GB │ IE │ NI
│
11
■