Maintenance And Cleaning - Beko EV7100 User Manual

4.12 Your machine is equipped with a
"Standby Mode"
In case of not starting any programme or waiting
without making any other operation when the
machine is turned on by On/Off button and while
it is in selection step or if no other operation is
performed approximately 2 minutes after the
programme you selected has come to an end, your
machine will automatically switch to energy saving
mode. Brightness of indicator lights will decrease.
Also, if your product is equipped with a display
showing the programme duration, this display
will completely turn off. In case of rotating the
Programme Selection knob or pressing any button,
lights and display will restore to their previous
condition. Your selections made while exiting
the energy saving mode may change. Check the
appropriateness of your selections before starting
the programme. Readjust if necessary. This is not a
fault.

5 Maintenance and cleaning

Service life of the product extends and frequently
faced problems decrease if cleaned at regular
intervals.
5.1 Cleaning the detergent drawer
Clean the detergent drawer at regular intervals
(every 4-5 washing cycles) as shown below in order
to prevent accumulation of powder detergent in time.
Press the dotted point on the siphon in the softener
compartment and pull towards you until the
compartment is removed from the machine.
C
INFORMATIONS
If more than normal amount of water and softener
mixture starts to gather in the softener compartment,
the siphon must be cleaned.
Wash the detergent drawer and the siphon with
plenty of lukewarm water in a washbasin. Wear
protective gloves or use an appropriate brush to
avoid touching of the residues in the drawer with
your skin when cleaning. Insert the drawer back
into its place after cleaning and make sure that it is
seated well.
15 / EN
5.2 Cleaning the loading door and the drum
For products with drum cleaning programme, please
see Operating the product - Programmes.
For products without drum cleaning, follow the
below steps to clean the drum:
Select Additional Water or Extra Rinse auxiliary
functions. Use a Cottons programme without
pre-wash. Set the temperature to the level
recommended on the drum cleaning agent
which can be provided from authorized services.
Apply this procedure without any laundry in the
product. Before starting the programme, put 1
pouch of special drum cleaning agent (if the special
agent could not be supplied, put max. 100 g of
powder anti-limescale) into the main wash detergent
compartment (compartment no. "2"). If the anti-
limescale is in tablet form, put only one tablet into
the main wash compartment no. "2". Dry the inside
of the bellow with a clean piece of cloth after the
programme has come to an end.
C
INFORMATIONS
Repeat Drum Cleaning process in every 2 months.
Use an anti-limescale suitable for the washing machines.
After every washing make sure that no foreign
substance is left in the drum.
If the holes on the bellow shown in the figure is
blocked, open the holes using a toothpick.
C
INFORMATIONS
Foreign metal substances will cause rust stains in the
drum. Clean the stains on the drum surface by using
cleaning agents for stainless steel. Never use steel wool
or wire wool.
5.3 Cleaning the body and control panel
Wipe the body of the machine with soapy water or
non-corrosive mild gel detergents as necessary, and
dry with a soft cloth.
Use only a soft and damp cloth to clean the control
panel.
A
WARNING
Never use sponge or scrub materials. These will damage
the painted and plastic surfaces.
Washing Machine / User's Manual