Troubleshooting - Beko EV7100 User Manual

7 Troubleshooting

Program does not start after closing the door.
• Start / Pause / Cancel button was not pressed.>>> *Press the Start / Pause / Cancel button.
Programme cannot be started or selected.
• Washing machine has switched to self protection mode due to a supply problem (line voltage, water
pressure, etc.). >>> To cancel the programme, turn the Programme Selection knob to select another
programme. Previous programme will be cancelled.
Water in the machine.
• Some water might have remained in the product due to the quality control processes in the production.
>>>
This is not a failure; water is not harmful to the machine.
Machine vibrates or makes noise.
• Machine might be standing unbalanced. >>>
• A hard substance might have entered into the pump filter. >>>
• Transportation safety bolts are not removed. >>>
• Laundry quantity in the machine might be too little. >>>
• Machine might be overloaded with laundry. >>>
load by hand to balance it homogenously in the machine.
• Machine might be leaning on a rigid item. >>>
Machine stopped shortly after the programme started.
• Machine might have stopped temporarily due to low voltage. >>>
restores to the normal level.
Programme time does not countdown. (On models with display)
• Timer may stop during water intake. >>>
amount of water. The machine will wait until there is sufficient amount of water to avoid poor washing results due to lack
of water. Timer indicator will resume countdown after this.
• Timer may stop during heating step. >>>
temperature.
• Timer may stop during spinning step. >>>
the unbalanced distribution of the laundry in the drum.
C
INFORMATIONS
Machine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any damage
to the machine and to its surrounding environment. Laundry should be rearranged and re-spun.
Foam is overflowing from the detergent drawer.
• Too much detergent is used. >>>
compartment of the detergent drawer.
C
INFORMATIONS
Put detergent into the machine suitable for the programmes and maximum loads indicated in the "Programme and
consumption table". When you use additional chemicals (stain removers, bleachs and etc), reduce the amount of
detergent.
18 / EN
(See "Cancelling the programme")
Adjust the feet to level the machine.
Remove the transportation safety bolts.
Add more laundry to the machine.
Take out some of the laundry from the machine or distribute the
Make sure that the machine is not leaning on anything.
Timer indicator will not countdown until the machine takes in adequate
Timer indicator will not countdown until the machine reaches the selected
Automatic unbalanced load detection system might be activated due to
Mix 1 tablespoonful softener and ½ l water and pour into the main wash
Clean the pump filter.
It will resume running when the voltage
Washing Machine / User's Manual