Removing The Transportation Locks; Appropriate Installation Location; Connecting Water Supply; Removing Packaging Reinforcement - Beko EV7100 User Manual

2 Installation
Refer to the nearest Authorised Service Agent for
installation of the product. To make the product
ready for use, review the information in the user
manual and make sure that the electricity, tap water
supply and water drainage systems are appropriate
before calling the Authorized Service Agent. If they
are not, call a qualified technician and plumber to
have any necessary arrangements carried out.
C
INFORMATIONS
Preparation of the location and electrical, tap water and
waste water installations at the place of installation is
under customer's responsibility.
Make sure that the water inlet and discharge hoses
as well as the power cable are not folded, pinched or
crushed while pushing the product into its place after
installation or cleaning procedures.
B
WARNING
Installation and electrical connections of the product
must be carried out by the Authorized Service Agent.
Manufacturer shall not be held liable for damages that
may arise from procedures carried out by unauthorized
persons.
A
WARNING
Prior to installation, visually check if the product has
any defects on it. If so, do not have it installed. Damaged
products cause risks for your safety.

2.1 Appropriate installation location

• Place the machine on a rigid floor. Do not place it
on a long pile rug or similar surfaces.
• Total weight of the washing machine and the
dryer -with full load- when they are placed on top
of each other reaches to approx. 180 kilograms.
Place the product on a solid and flat floor that has
sufficient load carrying capacity!
• Do not place the product on the power cable.
• Do not install the product at places where
temperature may fall below 0ºC.
• Place the product at least 1 cm away from the
edges of other furniture.

2.2 Removing packaging reinforcement

Tilt the machine backwards to remove the packaging
reinforcement. Remove the packaging reinforcement
by pulling the ribbon.
5 / EN

2.3 Removing the transportation locks

A
WARNING
Do not remove the transportation locks before taking out
the packaging reinforcement.
Remove the transportation safety bolts before operating
the washing machine! Otherwise, the product will be
damaged.
Loosen all the bolts with a suitable spanner until
they rotate freely (C). Remove transportation safety
bolts by turning them gently. Attach the plastic
covers supplied in the User Manual bag into the holes
on the rear panel. (P)
C
INFORMATIONS
Keep the transportation safety bolts in a safe place to
reuse when the washing machine needs to be moved
again in the future.
Never move the product without the transportation
safety bolts properly fixed in place!

2.4 Connecting water supply

C
INFORMATIONS
The water supply pressure required to run the product is
between 1 to 10 bars (0.1 – 1 MPa). It is necessary to have
10 – 80 liters of water flowing from the fully open tap in
one minute to have your machine run smoothly. Attach a
pressure reducing valve if water pressure is higher.
If you are going to use the double water-inlet product
as a single (cold) water-inlet unit, you must install the
supplied stopper to the hot water valve before operating
the product. (Applies for the products supplied with a
blind stopper group.)
If you want to use both water inlets of the product,
connect the hot water hose after removing the stopper
and gasket group from the hot water valve. (Applies for
the products supplied with a blind stopper group.)
Washing Machine / User's Manual