Snmp Function - Hitachi Compute Blade 2000 User Manual

SNMP function

SNMP function overview
(1) Functions
No. Function
1 Polling
2 Trap
The following image shows management by SNMP.
SNMP Manager
(NNM)
1. SNMP Polling Function
Support command (*1)
Maximum number of SNMP managers that
can be notified simultaneously
Supported modules
(*1) the Set command is not supported.
Allows the SNMP manager to recognize Compute Blade as
a target to monitor. When the manager requests information
on each object of Compute Blade private MIB (Management
Information Base), a response corresponding to the
information on the Compute Blade private MIB object is
returned. This function responds only to requests from the
IP address of SNMP Manager registered in the
management module.
Sends information spontaneously to the manager according
to the Compute Blade private management information
base (MIB). This enables the SNMP manager to monitor
faults.
SNMP Trap
SNMP Polling (Response)
MIB
MIB
項目
Object
SNMP Polling (Request)
Item
1562
Description
Response 応答
Chassis Config.
シャーシ構成
構成
Config.
Setting Info. 設定情報
情報
Info.
現状態
Current Status.
Request 要求
Compute Blade
(SNMP Agent)
Description
SNMPv1/v2c/v3 (Get, GetNext, GetBulk)
4
Server blade, management module, switch
module, power supply module, fan module,
PCI-e riser card (IOCD: input/output control
device)