Error At Server Blade Startup - Hitachi Compute Blade 2000 User Manual

Error at server blade startup

This section describes what action to take for errors that occur when the server blade boots up.
When error messages appear
When an error is detected during initial diagnosis, an error message appears in the
monitor displaying the server blade's screen. When an error message appears, take
appropriate steps to solve problems according to the "Cause and Action" listed below.
If the problem persists, or you encounter an error message that is not listed below,
write it down and consult your reseller or maintenance personnel.
Error message
No.
displayed on the screen
Complementary metal–
1
oxide–semiconductor
(
CMOS) battery failed
2 CMOS Checksum error -
Defaults loaded
3 Central processing unit
(
CPU) Failure
4 Hard disk Diagnosis fail
5 Hard disk fail
6 Hard Disk Self-Monitoring
Analysis and Reporting
Technology
Status bad
7 Memory Test Fail
8 Error Check and Correct
(
ECC) Correctable Error
Alert
Description
Button battery voltage
has dropped.
Button battery voltage
has dropped.
CPU has failed.
Hard disk has failed.
Hard disk has failed.
Hard disk has failed.
(
S.M.A.R.T.)
Memory has failed.
Error was automatically
corrected in memory.
1825
Cause and Action
Consult your reseller or
maintenance personnel.
Consult your reseller or
maintenance personnel.
Consult your reseller or
maintenance personnel.
Third-party memory and/or hard
disk are not covered by
Hitachi's warranty.
Confirm that the device supplied
by Hitachi is properly
connected. If a failure persists,
consult your reseller or
maintenance personnel.
This is not a failure.